Avanti Countertop Water Dispenser

Avanti Countertop Water Dispenser

Brand/Manufacturer: AVANTI PRODUCTS
Hpfy stores Save

Avanti Countertop Water Dispenser ensures best water quality results with the stainless steel reservoirs that makes water virtually free of all total dissolved solids such as Fluoride, Chlorine, Lead, Mercury, Nitrates and Sulfates. This water dispenser comes with zero-water filtering bottle system and consists of push button faucets for hot and cold water.

Features

  • Avanti Countertop Water Dispenser is perfect for home and office use
  • Separate hot and cold water power switches on the back of the unit
  • LED light indicators for power, hot and cold water functions
  • Hot water faucet safety lock
  • Removable drip tray

More Information

  • Installation guidelines:
    -
    Remove the exterior and interior packing.
    - Place your appliance on a countertop or surface that is strong enough to support the dispenser when it is fully loaded. The unit is provided with four plastic feet, if it does not sit level on the floor, adjust the front feet to level the unit well to the floor.
    - Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly.
    - Allow 5 inches of space between the water dispenser and the wall, which allows for proper air circulation to cool the compressor.
    - Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or remove the third (ground) prong from the power cord under any circumstances. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.
    - This water dispenser is not recommended for outdoor use.
    - Do not locate the dispenser in area where the temperature may fall below freezing (32º F).
    - Keep area around dispenser free of dust and dirt.
    - Keep the reserve supply of water bottles away from excessive heat and light.
    - Never unplug the water cooler, except for maintenance.
  • Operation Instructions:
    -
    Before Using Your Water Dispenser
    - Check to be sure the following parts are included:
    A. Instruction manual
    B. 2 extra cup dispenser cabinet plugs
    C. 2 extra drain seals
    D. Accessories order form.
    - Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
    - The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows:
    - Keep the unit unplugged.
    - Fill water tank with tap water full to capacity. Wait for 5 minutes until water settles.
    - Slide child safety button then push the hot water faucet until water comes out, then stop.
    - Plug the dispenser into the electrical outlet. We are ready to complete the first cycle. In order to do that, wait for the hot water to reach temperature in approximately 10 minutes, and then wait for the cold to reach temperature (another 40 minutes, approximately).
    - Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at a time until no more water remains. (Note: To facilitate this operation, use a large container).
    - Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains completely.
    - Proceed to close the drain cap.
    - Remove the cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.
    - Place the 5-gallon bottle of water on the water intake, allow water to stand for approximately one minute.
    - Push water faucet buttons to insure water flows from both faucets.
    - Plug dispenser back into the electrical outlet.
    - Now you are ready to use your water dispenser.
  • Care and Maintenance:
    - Wash the inside of the reservoir with a warm water and baking soda solution. - The solution should be about 2 tablespoons of baking soda to a quart of water. (Turn off the hot water function).
    - The drip tray and water faucets should be cleaned with mild detergent and warm water.
    - At regular intervals or once a month inspect the coils located across the back of the dispenser. Vacuum accumulation of dust or clean it with a hard brush.
  • Warning:
    - To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions:
    - Read all instructions before using the water dispenser.
    - Never clean parts with flammable fluids. The fumes can create a fire hazard or explosion.
    - Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other water dispenser. The fumes can create a fire hazard or explosion.
    - Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center.

Specification

ParticularsSpecifications
Color White
Dimensions20.5"H x 12.25"W x 14.25"D
(37"H with Bottle)
Weight36lb
Power  110V / 60HZ

Warranty

6 month limited warranty

Customer Reviews

Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*


Submit Cancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.damozelle.com

Close